The picture shows
Skandic 1500x750 without system, with front and end.

Description
Skandic supplied with installed waste/overflow outlet and tiltproof plinth. The bathtubs are available with three different massage systems but can also be ordered complete without the system. The bathtubs are suitable for recessing and for installation with front and end. Choose the correct front/end using the sketch for the relevant bathtub (A-D). Rectangular whirlpools can only be fitted with one front panel when one or two side panels are fitted.

Approval & standards


Logistics
The bathtub is supplied complete and assembled, with transport protection, on pallet. For weights, see the table below. The pallet weighs 20 kg. Fronts and ends are supplied installed on the tub.

Components Connection
Water volume 210 liters.

Complementary information
NOTE! Any options should be made when ordering the bathtub.
*)It is not possible to post install on already supplied bathtubs.

Montage
Always follow all instructions/directions supplied with each bathtub. When recessing, note where the bathtub feet are mounted so that a foot does not end up in the middle of the floor well. Any problems regarding the positioning of feet in an existing bathroom can be remedied. Contact our customer service for advice and assistance. Under the "Downloads" tab you will find technical drawings of the bathtub as well as feet and mixer locations. From there you can also download the directions for use. There are different types of mixers that can be installed in the bathtub. For range, see supplementary products.