The picture shows
Design front frame 1700 x 700. Front and end, wave. Bathtub 1700.

Description
The front frame is available in two colors; white powder paint or silver anodized aluminum. Two different patterns of design front and end panels in frosted safety glass are available for the front frame. In addition to our own standard bathtubs the design front frame can be used for rectangular bathtubs of corresponding size in Bette's range. The frame is made of aluminum. Design front frame is 50 mm higher than most of our complete and half front frames and is therefore also suitable for all tubs with overflow outlets. The frame has feet with 25 mm of adjustment. Order fronts and ends according to the number of visible sides. In cases where the bathtub is installed with two long or short sides visible, additional mounting instructions should be ordered with the extra front or end. Indicate the width/length of the extra side of the bathtub.

Logistics
Frame and fronts and ends are supplied packaged together in separate boxes. For weights, see the table below.

Complementary information
Note. Safety glass is highly resistant to knocks and bending. However, the material does not tolerate blows to the corners or edges. These are protected after installation but not during fitting. Always use a soft under lay when the glass is placed on the floor. Glass with damaged edges should not be installed and should be replaced immediately!

Montage
The front frame is installed on a frame and placed in position. The frame is adjusted horizontally using the adjustable feet. The bathtub, which is equipped with a damping/friction material, is placed in the frame. The plastic waste pipe is cut and connected to the floor well, alternatively the overflow outlet system is connected to a waste pipe. The front/end is then installed, which can later be removed for inspection or when cleaning. Installation instructions are included.