The picture shows
Bathtub 1300 with full front frame 4013.

Description
Supplied without support, but with waste pipe, installed waste fitting and chromed waste plug with chain and suction pad. Designed for installation with full or half front frame. The bathtub is made of enameled steel plate. The frame is made of powder-coated aluminum and has feet with 25 mm of adjustment. The front frame can be slid sideways and inwards in relation to the bathtub to provide space for pipe routing on walls. The lower section of the full front can be slid up to increase accessibility when cleaning. Full and half front frames are supplied with a visible front and end as standard. In cases where the bathtub is installed with two long or short sides visible, supplement with additional front or end.

Approval & standards
The product follows AMA recommendations as well as SS-EN 232.

Logistics
The bathtub is transport-protected on pallets with up to 13 tubs per pallet. For weights, see the table below. The pallet weighs 16 kg. The frame, fronts and ends are packed separately.

Components Connection
Bathtub water volume 80 liters.

Complementary information
The bathtub can be ordered with an anti-slip treated bottom and/or support handle.

Montage
The front frame is installed on a frame and placed in position. The frame is adjusted horizontally using the adjustable feet. The bathtub, which is equipped with a damping/friction material under the corners, is placed in the frame. The plastic waste pipe is cut and connected to the floor well. Installation instructions are included.